1.5 to 30 MHz HF Whip Antenna Kit for Vehicle and Shelter.
	Part number: ABP-ANT-HF120VK For tactical operation of AN/PRC-104, AN/PRC-137, AN/PRC-138, AN/PRC-150 and other HF tactical radios. This antenna is field proven and combat tested worldwide. Frequency: 1.5 - 30 MHz Polarization: Vertical Radiation: Omni-directional Max Power: 1,000 Watts NVIS tilt spring base Near Vertical Incident Signal (NVIS) Forward or reverse tilt Spring-loaded locking pin permits quick change of tilt angle settings. Operating Temperature: -40°C to +80°C Environmental: For all weather environments. Meets rigorous military applications. MIL-STD-810 Weight: 10 lbs Color: Military Green Supplied with 3/8” stainless steel mounting bolts and hardware.
Antenna mount for HF Whip Antenna. For Vehicle.
	Part number: ABP-MNT-4257 Utility steel bracket per ASTM A-589 Finished in military green Mounting bolts not supplied.
Antenna mount for HF Whip Antenna. For Shelter.
	Part number: ABP-MNT-42403A Utility aluminum bracket Finished in CARC military green Adapter plate included Steel reinforcing backing plates and dust cover supplied. Mounting bolts not supplied.
Broadband Manpack Antenna for Rapid Forward Deployment
Part numbers: ABP-ANT-HF90G (green color), ABP-ANT-HF90S (sand color) Rapid Deployment. One man can set up the antenna in under 5 minutes. Complete. The center assembly, two spreaders, and two wire assemblies comprise the entire antenna. Small & Light. Look at the pictures above. Nothing could be smaller and operate HF! Weighs only 5 lbs. Performance. Light and easy to handle. Super flexible insulated wires. Operates 1.6 - 60 Mhz without a coupler required. Camouflage. Available in forest green and sand colors. Use with ABP-MNT-306T-G or ABP-MNT-306T-G mast kit. Specifications: SWR less than 1.5:1 from 1.6 to 30 Mhz SWR less than 2:1 from 30 to 60 Mhz Lowest noise for unmatched reception No antenna tuner/coupler required 20 watts PEP continuous #14 insulated super flexible copper wire 50 ohm input with BNC connector Weighs 5 lbs
Composite Fiberglass Mast Kits for Rapid Forward Deployment Manpack - NVIS
Part numbers: ABP-MNT-306T-G (green camouflage), ABP-MNT-306T-S (sand camouflage) Rapid Deployment. One man can set up a 6 ft mast section in under 5 minutes. Complete tactical kits include the poles, pins, carry bag, hammer, preassembled guy lines - everything. Small & Light: These pole kits break down to just 18 inches in length. Easy to carry, a complete 3-pole 6 Ft mast kit weighs just 17 lbs. Safety & Performance: Light and easy to handle. NO SHOCK HAZARDS! Performs better with radio than metal or carbon fiber poles. Camouflage: Available in forest green and sand colors. Use with ABP-ANT-HF90G or ABP-ANT-HF90S antenna. Specifications: Height: 6 Ft Guy Spread: 3 Ft Guy Tension: 5 - 10 Lbs Halyard Tension: 40 lbs max Downward Press: Up to 25 Lbs depending upon guys, halyards, and wind Wind Loading: Approx 5 Lbs sideways Weight: Approx 17 Lbs for complete kit
Broadband Folded Dipole Antenna for ALE and NVIS for Tactical Rear and Base
Part number: ABP-ANT-HF90N Frequency Agile. The new standard for military, government, homeland defense. Hop frequencies at any speed as long as you want, as there are no mechanical parts or active components to wear out. ALE radios allow reliable HF communications in any weather, day or night, without an experienced operator. Military/Govt. This one antenna performs short, medium, and long haul, NVIS, and ALE. Whatever the mission, this antenna will perform. Low cost. Utilize one antenna instead of several. No need for an antenna coupler/tuner. No antenna switches. Performance. Not limited to conventional ham bands. Tune any frequency in the antenna's bandwidth, and have VSWR of 2:1 or better in HF. VSWR of 3:1 or better from 30 - 60 Mhz. Capture weak signals in receive mode. Much better performance than any vertical. Very reliable. Simple to Install. Easy to install as inverted Vee, flat top, or sloper. Just put it up! No adjustments of any kind. No tuning. Completely assembled. No grounds to play with. Simple to Use. Utilize personnel with far less training. No more choosing which antenna to use, no endless playing with a tuner. Use with ABP-MNT-312T-G or ABP-MNT-312T-S mast kit. Specifications: SWR less than 2:1 over entire HF frequency range for the model SWR less than 3:1 from 30 to 60 Mhz Lowest noise for unmatched reception No antenna tuner required for HF 2 KW PEP Input Power, 1 KW PEP Output Power SSB/CW ICAS (Intermittent Commercial and Amateur Service) #14 stranded stainless steel wires 50 ohm input with N connector Comes completely assembled, easy to install Install as inverted Vee, flat top, or sloper
Composite Fiberglass Mast Kits for Rapid Forward Deployment Tactical Rear and Base - NVIS and Inverted Vee.
Part numbers: ABP-MNT-312T-G (green camouflage), ABP-MNT-312T-S (sand camouflage) Rapid Deployment. One man can set up a 12 ft mast section in just 5 minutes. Complete tactical kits include the poles, pins, carry bag, hammer, preassembled guy lines - everything. Small & Light. All of our pole kits break down to just 4 ft in length. Easy to ship, easy to carry. A complete 12 ft mast kit weighs just 10 lbs. Safety & Performance. Light and easy to handle. NO SHOCK HAZARDS! Performs better with radio than metal or carbon fiber poles. Camouflage. Available in forest green and sand colors. Use with ABP-ANT-HF90N antenna. Specifications: Height: Up to 12 Ft Guy Spread: Half the height Guy Tension: 5 - 10 Lbs Halyard Tension: 40 lbs max Downward Press: Up to 25 Lbs depending upon guys, halyards, and wind Wind Loading: 12Ft @ 50 MPH is approx 10 Lbs sideways Weight: 12 Ft Mast weighs 5 Lbs, approx 10 Lbs for complete kit

For accessories, price and ordering information call ABP at (301) 977-5570, Fax to (301) 977-5210 or E-mail to: info@abp.com